Rectifier circuit

bridge rectifier symbol Rectifier circuitTo generate a DC voltage such as primary cells (batteries) and a secondary cell (battery). They produce a DC voltage by converting chemical energy into electrical energy.

The alternative is to generate a DC voltage of the AC voltage. This valve is made of the effect of the pn junction of a semiconductor diode.

Note: The following circuit is a resistor in series to the diode. Resistance is needed to perform measurements with an oscilloscope. Without resistance there will be no closed circuit.

Half-wave rectifier circuit
Half wave rectifier circuit Rectifier circuit
Half wave rectifier circuit. It consists of a simple diode. The polarity of the diode determines whether positive or negative voltage is applied to the output of the circuit.
The fact that the semiconductor diode, passing current in only one direction, locking the second half coming from the AC waveform.
Oscilloscope view of the input voltage U e Rectifier circuit
On receipt of the half wave rectifier circuit an ordinary sinusoidal AC voltage is applied.

Oscilloscope view of the output voltage Ua Rectifier circuitAt the output of a half wave rectifier circuit produces a DC voltage pulse. Because current flows in one direction through the diode, which is missing in every second half cycle of alternating current in the output voltage U.
Under resistive load (resistance R) breaks pulsed DC voltage U DC with ripple.

Center two-way rectifier circuit

Oscilloscope view of the output voltage Ua full wave Rectifier circuit

The center two-way rectifier circuit is called a two-pulse midpoint circuit M2. It requires a transformer with a center, in the current can flow back. The two diodes, the current of two half-cycles of the input voltage U e of a point out of the circuit. On a common line to the transformer, the currents are reduced.

Oscilloscope view of the output voltage Ua full wave1 Rectifier circuit

The current flow through the diode D 1 is unchanged on the Resistance. Because of the diode D 2 , it can not flow into the transformer.
The current flow through the second half wave is determined by the diode D 2 out. Through the diode D 1 , it can not flow to the transformer. The flow of the second half cycle is conducted through the resistor to the center tap.

Bridge rectifier circuit

Bridge rectifier circuit Rectifier circuit
The bridge rectifier circuit is also known as two-pulse bridge rectifier circuit B2. It consists of two parallel pairs of diodes. The AC input is located between the diode pairs.
The arrangement of the semiconductor diodes in the circuit of AC current flows in two different paths through the circuit.
The consumer is always traversed in one direction of flow.

Oscilloscope view of the output voltage Ua full wave1 Rectifier circuitThrough the diode circuit, the current flow through the second half wave is altered so that the output voltage U a pulsates. It is also known as pulsating DC voltage at which the second half cycle of input voltage U e is flipped up.
Under resistive load breaks the pulsating DC voltage U DC with a ripple.

pinit fg en rect gray 20 Rectifier circuit

  Title :   Rectifier circuit
  Category :   Stabilization circuits.
  Tags :   bridge diode,  bridge rectifier,  full wave rectifier,  Half-wave rectifier,  Rectifier circuit, 


Do you have any comments on Rectifier circuit ?

Search to this Rectifier circuit post: rectifier circuit, rectifier, bridge rectifier circuit, dv output from transformer rectifier circuit, power rectifier circuit maintenance of ac drive